Recent content by Dae Tripper

Me please!

Yum yum, thanks Tugger!

Use one of these, it gets some oxygen in too. But get it from Plasdene http://keg-king.com.au/tap-in-cap-cube-tap-with-venting-valve.html

Hey Tugger, that looks great! Could you please elaberate on the brine, smoke times and temps? I am keen to give it a try.

Seals rather well, the feet put a bit of extra pressure that helps it conform.

Here is mine. I ended up putting large stainless washers around the o rings to stop them poping out under any more than hand torque. Made it with an angle grinder (cut and flap disc), die grinder but mainly rats tail file, because the die grinder bit was stuffed.

Have it at the same pressure/purged before you start, go slow in the beginning. It is generally clean but brewing brings out the catastrophe in me.

Thanks Grumpy. It is very tempting...

Seems like they want to push people towards cheap drugs like ice instead.

I am interested Dan :cheers:

My yellow bin does a better job.

They are yum, DO IT!

Mmmm... Where have I seen that lathe? Still very jealous of the mill too.

Not a chance. Concider leaving a pub, should they be liable?

You could go high tech and get one of these www.grainandgrape.com.au/products/category/VIPRMNCD-new-products/7HYDRO%20TILT--hydrometer-tilt-wireless