Hi I’ve recently purchased a couple of KL20749 black/yellow duotight disconnects which fit perfectly on the Beer outposts. I also picked up a couple of KL29756 grey/red disconnects which fit both gas (in) and beer (out) posts is this normal please ?
Hi I just purchased 4x KL 17817 nukatap- FC shuttles Gen 2 only to discover that I also need an additional spring (x4) to upgrade my original taps however I can’t find them anywhere. Can you assist please.
Hi The clicking relay sound is not present when the PID is switched off.
The frequency of the ‘clicks’ coincide with the Relay cycle time (The default appears to be 5 seconds ) Is this normal ?
As to the probe settings I had switched the thermo probe off hence it not showing on the video...
Please ignore the above post I have now registered the Controller and Blue tooth is now working 👍🏼
However the controller is now making a clicking sound which sounds to me like a relay. Is this normal ?
I have three controllers and this is the only one that clicks !
Hi I have been using a RAPT controller to control my mash and boil elements with great success. I have just purchased a RAPT thermometer with the intention of pairing it via Blue Tooth however the Blue tooth option doesn’t appear in settings and I can’t find the answer in the instruction manual...
Hi many thanks for that but I’m still confused . Are you saying that both the 10 amp version and the 15amp version are identical except the 15 amp (KL 30410) has upgraded cables and plugs
Many thanks
Anyone got any advice on fitting a thermowell to the Fermzilla Gen 3 Tri clover lid?
It doesn’t look like there is enough room for the retaining nut to fit without fouling the sides of the lid. I don’t want to drill it out using the dimple underneath as the guide as it appears to be off centre !
Many thanks for the information I have a kegland Mk 4 Beverage N2 Mixed gas regulator with a bullnose fitting however the bullnose appears to be stainless and not brass as shown in the above picture. This is a brand new unit not dropped or scratched in any way, even when I use maximum torque it...
@KegLand-com-au Hi I have just purchased a MK4 mixed gas regulator in the UK and I can’t make a tight seal onto the gas cylinder. I have spoken to a gas supplier who states that mixed Gas regulators in the UK usually have a washer between the regulator and the cylinder. There wasn’t one...